Skip to content
SilktideHelp

Where Silktide connects from

Silktide's testing browsers run on AWS and normally use a large, dynamic set of IP addresses. Allowlisting that entire range is usually impractical for a firewall team.

Prefer a proxy

In the Proxy section of the website's Advanced settings, pick a Preset. Testing then comes from two fixed Silktide IP addresses for that region (EU, US, or Australia). Use the preset closest to where the site is hosted when you can - or closest to the audience whose experience you care about, if the site varies by geography.

A proxy is also the usual first fix when:

  • Bot protection blocks or challenges the crawler
  • Silktide sees different content than you do because of geo-targeting
  • Your security team needs a short allowlist instead of a wide AWS range

See When crawling fails for the full troubleshooting path.

Proxy IP addresses

PresetIP addresses to allowlist
EU (Dublin)52.18.199.206, 52.209.191.79
US (Ohio)52.14.69.69, 18.224.35.114
AU (Sydney)3.104.57.83, 3.24.44.162
  • Allowlist both addresses for the preset you pick. Silktide may use either one for any request.
  • Set the preset as well as the allowlist. Testing only comes from these addresses when the website uses that preset. With No proxy, it comes from the wide AWS range; with a custom proxy, it comes from your proxy.
  • The change applies from the next test. Save Advanced settings, then retest.

These addresses rarely change, and we update this page when they do. To double-check them before building a firewall rule, contact Silktide support or your Customer Success contact.

User agent

Silktide imitates the device it is simulating (desktop or phone) and appends a configurable suffix - by default including "Silktide". Your server logs can use that suffix to identify testing traffic.

You can change or remove the suffix in Advanced settings. Some sites that already trust a known Silktide user agent may prefer stealth mode off; others need stealth on to look more like an ordinary browser. Those trade-offs are covered under Loading a page.

Last updated

Was this page helpful?